Cable storage bracket is a bracket or rack built into electrical equipment rooms such as buildings or underground passages to facilitate the storage and management of redundant cable lines. It is an important accessory used in transmission lines and has the effect of supporting fixed wires and optimizing tension distribution. The cable storage bracket can keep the cable lines neat and orderly, reduce the sagging and vibration of the wires, and allow the safe and stable operation of the computer room cable lines. It is suitable for various high-voltage transmission lines and complex terrain environments.
Before installing the cable storage bracket, you need to prepare the relevant tools and installation sites. Tools include screwdrivers, wrenches, pliers, electric drills, etc. The place needs to have the basic conditions for installation, such as flat walls and no obstacles.For safety, the equipment should be checked for normal operation before installation.
After the preliminary preparations are completed, the hardware cable storage bracket suitable for the site requirements should be selected and installed in accordance with the design requirements. Usually fix the hardware cable storage bracket to the wall where the optical cable is to be installed. First make a hole with a screwdriver, and then use expansion screws to fix the hardware cable storage bracket to the wall. When installing the hardware cable storage bracket, pay attention to whether the installation location is horizontal to prevent it from affecting the communication effect of the cable.
The installation of the clamp is the key link to correctly fix the remaining cables of the optical cable on the hardware cable storage bracket. There are two types of wire clamps, vertical wire clamps and horizontal wire clamps, and the corresponding wire clamps are selected according to the specific circumstances of the installation. The installation of the vertical clamp should fix the clamp at the starting position of the hardware cable storage bracket, then pass the remaining cable of the optical cable through the clamp, and adjust the length so that it will not be tripped or knotted. After the adjustment is completed, a plastic or rubber isolation belt can be added between the clamp and the fiber cable to prevent the fiber cable from being crushed. The installation of the horizontal clamp requires drilling holes in the hardware cable storage bracket first, and then installing the clamp on the hardware cable storage bracket. The clamp can fix multiple fiber cables at the same time, and pass the optical cable through the clamp. To determine the appropriate tension of the optical cable, the clamp must be flush with the hardware cable storage bracket.
The fixing of the cable is to make the cable stable on the hardware cable storage bracket without bending or loosening. You can use a line card to fix the optical cable, adjust the tension of the cable, and put a plastic gasket between the line cards to prevent damage to the cable during maintenance. When the cable reaches the wall and needs to turn, an elbow should be used at the turn. During the installation process, the operation must be carried out in strict accordance with the design requirements, so that the communication efficiency can be improved while being safe and reliable.